shqiptare
euskara
Zulu
Latinus
Cymraeg
தமிழ்
Slovak
Slovak
Afrikaans
Focus on news
news information
Low price Medium Air Pressure DTH Hammer suppliers introduce the structure of DTH Hammer
2023/03/31
Low price Medium Air Pressure DTH Hammer suppliers tell you that the standard square sleeve on the upper part of the extended drill pipe is connected to the drill pipe, the middle part is an internal hollow core tube, and has a gas pipe interface device, and the bottom is connected to the DTH hammer by the butt flange; the DTH hammer The upper part is a chip container, the inside of the hammer body is a cluster cylinder and piston device, and the bottom is a hammerhead.
Hammer distribution. Low price Medium Air Pressure DTH Hammer suppliers tell you that the hammerhead is arranged without a blind area, that is, each is responsible for its own responsibility. The center hammer is a single hammerhead, and the hammer body rotates 180° left and right. Break the center position; the secondary center hammer is a double hammer One head, breaks the periphery of the center hammer; the secondary side hammer has three hammer heads, which break the inside of the side hammer; the side hammer has five hammerheads, which break the edge.
airway. Low price Medium Air Pressure DTH Hammer suppliers tell you that except for the side hammer, all internal hammerheads have exhaust ducts on the drill body, and the finished piston discharges the air volume from the air hole along the exhaust duct on the drill body Leak out and blow up the broken rock debris at the same time.
Through the above introduction and analysis of the Low price Medium Air Pressure DTH Hammer suppliers introduce the structure of DTH Hammer, hope it helps you.
Related News
2022/06/10
2022/06/10
2025/06/04
2025/06/01
E-mail:
Add: No.4855 Shugang Avenue, Jingqing Town, Luqiao District, Taizhou city, Zhejiang Province
Tel: +86-576-82737372
Copyright @ 2022 Pulanka Rock Tools . All Right Reserved. SEO Powered by www.300.cn
